GLASS PUTTY GREEN: 0RS007-0.5KG, 0RS007-1.8KG, 0RS007-1KG

 

Characteristics:

Putty with fiberglass. It is characterized by particular ease of modeling and sanding with high grit abrasives. The possibility of using higher grit abrasives (coarse sanding P120 - P150) and the adjusted hardness of the putty to the paint coatings eliminates the formation of transitions between the putty and the repaired surface. Thanks to this, the putty can also be used directly under the filler primer. For filling irregularities on steel, aluminum, and polyester-glass surfaces. Intended for manual and machine processing with dry abrasives. It can be easily modeled even on surfaces with complex shapes, even when applying thicker layers. It does not clog sandpaper during sanding. It has very good adhesion to the substrate, and is used, among other things, to reinforce the surface weakened after sheet metal repair, increasing the mechanical strength of the repaired element.

Method of use:

The repaired substrate must be clean, dry, degreased, and matted. Thoroughly mix the putty mass with the hardener in an amount of 2-3% by weight, then apply to the substrate for about 5 minutes at 20 ^oC - higher temperature shortens the product's life and accelerates the curing process.

WARNING: Overdosing the hardener may cause discoloration of the topcoat. It is not recommended to use the product at temperatures below 15 ^oC.